DIY منبع تغذیه کامپیوتر به شارژر باتری – در خانه درست کنید

در کانال YouTube ما مشترک شوید –

موارد لازم برای شارژر باتری –
1. SMPS رایانه ای
2. 12 باتری
3. اتصال باتری
4. سیم بلوز

برخی از ویدیوهای خلاق دیگر ما را بررسی کنید –
************************************/ ***
چگونه یک چاقوی چاقوی قدرتمند در خانه درست کنیم –

چگونه یک پنکه برقی در خانه تهیه کنیم –

چگونه یک ماشین DIY DIY Highspeed را در خانه درست کنیم –

سلام فشرده سازی چراغ قوه آلومینیوم با فشرده سازی و نقد و بررسی –

چگونه یک ژنراتور انرژی الکتریکی در خانه ایجاد کنیم –

چگونه می توان با استفاده از هدفون های قدیمی ، از گوشی تلفن محافظت از ضد پیری استفاده کرد –

نحوه ایجاد یک KITY با مقاله های خبری قدیمی –

Unboxing anr Review BOSCH Gsb 10 RE دستگاه مته –

نحوه ساخت دستگاه طبل سانتری درام در خانه –

چگونه یک روبات DIY Crazy Walking Insect ایجاد کنیم –

نحوه ساخت چراغ قوه اضطراری با استفاده از موتور DC –

نحوه ساخت برش فوم برقی در خانه –

************************************/ ********

از تماشای شما متشکرم ..

لینک دانلود

45 پاسخ به “منبع تغذیه کامپیوتر DIY به شارژر باتری”

  1. If you are going to put up DYI videos, you should first understand DC electricity and batteries. A fully charged 12 volt battery charges to over 13 volts dc. Using a PC power supply will only bring the battery to 12 volts, thus only partially charged and wont get much use from it. Plus you should never use more than 10% of a lead acid batteries capacity to ensure the battery retains it's cycle capacity. Charging to 12 volts is 88% of it's charge rating, thus you are already quickly destroying the battery.

  2. Sorry this will not work as an SLA battery needs to be charged to 14v for a short while then float charged at 13.8v to get a full charge. This will kill your battery in very short time as it will only be partly charged and will sulphate up quickly.

  3. lo más probable es que no cargue del todo.
    No entrega cuántos amperes entrega y par que la carga sea efectiva, debe ser e un rango de 13.5V a 14.5V NO MÁS porque dañas la batería.

  4. Power suply keluaran tegangan12volt DC murni,mau isi batt kering yg tegangan 12,4-12,7volt DC, ngisi sih,tapi cuma sedikit ga maximal.Harusnya keluaran power suply 14-15 volt DC yg kasar, maksud nya tidak pakai capacitor electrolite( elco) di keluaran +&- nya,ini baru bisa ngecharch maximum(full) ngisi nya.

  5. This is very dangerous. Power supplies in general didn't design to charge batteries so there is no over charge protection built-in. When a battery is fully charged it will keep pushing more current until it burns.

  6. man 12v battery chargin with 11.80v nope
    Cycle use: 14.6-14.8V (25°C)
    Initial current: Less than 2.7A
    Standby use: 13.7-13.9V (25°C)
    writen on the type of batteries you used 😀

نظرات بسته شده اند.