24 پاسخ به “سایت pfSense به سایت VPN”

1. 👍

2. thanks a lot for your video !

3. this did not work for me, BUT i was able to get it working by adding the interface for the vpn on each side, seems that step was missing. this link shows how i got it working and includes the missing steps: https://www.nanoscopic.de/2017/07/simple-site-to-site-vpn-with-pfsense-and-openvpn/

4. Congratulations! very well explained and uncomplicated… Thank you! by Brazil.

5. Hello , we have 5 locations and in each one there are 2 PC that it will access to data on server that is located in another building. does pfsense with openvpn support that . or there is a good solution. thank you

6. Thank you, you are great

7. what about spanning VPN connections?

8. Hello Sir, It is great video

9. Senkyuu wery mucxx 😉

10. just wondering, i have successfully set this up on site b where i can access site a, but seems that on site a we cannot access site b, is this one way only?

11. i ran into an issue where it was pending to make sure this doesnt happen make sure the compression options for both routers are the same, in my case i used "omit preference – use openvpn default"

12. Hi, great tutorial…
    If i want to add another server to make a multiple site's, what where i need to add ip? for example, the new server have 192.168.50.0/24...

13. Krasavjik_atvijay!!!!

14. Is this a split tunnel setup or is it directing all traffic over the tunnel?

15. Why using OpenVPN, when you can use IPSec lan-2-lan?

16. i mis a network draw, to get hold of where any IP set is in use.

17. Thank you!

18. The tunnel address should use a /30 or /31 instead of /24. No reason to allow for extra IPs on that network.

19. Thanks for this short simple and to the point.

20. Any update on possibility of a VPN setup site to site using two EdgeRouters? Specifically the EdgeRouter X.

21. Is there any change that you guys can make a video about IPsec dial-in from a EdgeMax Router to a pfSense IPSec server

22. Thank you for this video! It was very helpful and easy to follow through!

23. Do you need static IPs for this work?

24. Thanks for the video. I attempted this with two pfSense boxes each with a public IP, but was unable to get it to work. Did I miss a step?

نظرات بسته شده اند.