27 پاسخ به “ساخت میز کامپیوتر نهایی – قسمت 2”

  4. VCT tile make a great bench top; I’ve topped most of my garage benches. Run a 3/4” trim board in the front glue the tile down from the back then use a flush trim router bit to cut the tile on the front. Or glue tile on the front first. There are some nice acrylic hard coatings that work great on top. CA glues, high viscosity ones, work well to hold small pieces down and gives you 30 seconds to position them.

  5. "I chose floor tiles so that I can remove a damaged tile for repair later… so for adhesive i'm choosing the stuff that's practically impossible to ever, EVER get off should I need to…"

    😉

    Alright. So I was faced with this exact situation not long ago. I chose contact cement to glue tiles on a wall so that I could get them off later without murdering the wall. The CC is holding up wonderfully to everyday use and I'll be able to remove them when I need to.

  11. this series is giving me some great ideas.
    I'm going to try and clear out my closet of all the useless junk, and get some smaller shelves to put in there. Then I'll get rid of my dresser, and desk which is basically just a glorified TV stand, and I'll finally quit it with the wireless keyboard, and the TV as a monitor, and go for a more traditional PC gaming set up.

  14. Its funny seeing nerds try to do MAN stuff! Use the friggen glue made for vct tile! If you want to repair it use a heat gun it comes right up! USE THE GLUE MADE FOR IT! I know this is a old video but STILL!!!

  15. It's a shame I'm not in to computers, because if you made such good videos on furniture making, I can only imagine what your other content is like!
    Cheers!

  21. when your using contact adhesive on an edge of particalboard or MDF you should primer it. Should also available at the same store as the adhesive,
    Also Contact adhesive should be applied with a fine Glue trowel, (not sure if this is named correctly). apply it on Both of the pieces you want to glue and let that dry as described on the bucket. Sticks istant and better! Roughing up the Vynil wil also increase strenght. i'm aware that you want to be able to replace a piece if it get damaged but with a heat gun it should come loose. Alternative was using melaminated partical board With a print those are cheaper as a sheet of laminate, but less resiliant. i Don't want to be rude i just want to give some info. 4-5 years later.

نظرات بسته شده اند.